Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Florissant Homeowners
A broken spring is the most common call we get, and it’s the one that stops everything. The door won’t lift, or it lifts a few inches and slams back down, and suddenly the car is trapped and the house is open. We handle garage door spring repair as a specialty, not a side job, and our technicians have up to 9 years of experience with the torsion and extension systems found in Florissant garages. We can often get you back in working order the same visit. The parts that fail most are the ones we carry on the call, and spring replacement is booked as a deliberate, careful job. Call (844) 943-4245 for a free estimate and available same-day service.
What Our Garage Door Spring Repair Service Includes
Springs do one job: they counterbalance the weight of the door so a person or an opener can lift it. When one lets go, the door becomes heavy and unpredictable, and a trained technician is the right call. Here’s what each part of our spring work covers.
Torsion Spring Replacement
A torsion spring is the coiled spring mounted on a steel shaft above the door, and it does the lifting work by twisting rather than stretching. Most modern Florissant garage doors run one or two of these, and a snapped torsion spring usually means the door won’t open at all. We replace the failed spring with a matched one, reset the drum and cable tension, and adjust the opener’s travel so the door runs evenly again. A matched pair is almost always replaced together, since the second spring has taken the same wear.

Extension Spring Replacement
Extension springs are the older style, mounted along the horizontal tracks on either side of the door, and they stretch instead of twisting. When one breaks, it recoils toward its anchor point, which is why a safety cable along the length of the spring matters. We replace the failed spring, install or renew the safety cables, and check the pulley and anchor hardware for wear. If your door has the older open-hook or clipped extension springs, we’ll tell you honestly whether replacement with the same type is the right move or whether a torsion setup makes more sense.

Broken Spring Repair
A broken spring is usually a clean break in the coil, and the door becomes very heavy the moment it happens. We diagnose which spring failed, check the door’s balance, and replace the broken spring with one matched to the door’s weight. We also look at why the spring failed, whether it’s age, fatigue, or a door that’s been running out of balance, so the replacement isn’t just putting the same problem back in the same place.

Spring Adjustment
Sometimes the spring isn’t broken, it’s just out of tune. A door that drifts down on its own, closes too hard, or feels heavier than it should often needs the spring tension adjusted rather than replaced. We balance the door so it stays put halfway open and lifts with light effort, then set the opener’s force and travel to match. Getting the balance right protects the opener, the springs, and the door itself.
Safety Cable Installation
Safety cables run through the center of extension springs and catch the spring if it ever breaks, keeping the pieces from flying across the garage. They’re required on most extension-spring doors, and a lot of older Florissant garages either don’t have them or have cables that are rusted or loose. We install new cables rated for the door’s weight and secure them at both ends. This is one of the simplest things you can do to make an older door safer.
Spring Inspection
A spring inspection is a quick, careful look at your springs, cables, drums, and rollers while the door is under tension, and it’s the best way to catch a failing spring before it strands you. We check the coil for gaps or rust, the cables for fraying, and the door’s balance, then tell you what needs attention now and what can wait. If everything is fine, we’ll say so, because there’s no reason to replace a spring that still has life in it.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Spring Repair
We work on the brand already in your garage, and that matters when the spring is matched to a specific door’s weight. Raynor doors have their own counterbalance setups and we know how their torsion and extension systems are put together. LiftMaster is one of the most common opener brands we see paired with spring systems, and we’re fluent in how its safety reverse interacts with a freshly balanced door. Chamberlain openers show up everywhere in Florissant, and we know how they behave once the spring tension is reset.
Genie systems, including their screw-drive openers, come with their own quirks around force settings, and we adjust accordingly so the opener and springs work together. Whether you have Raynor, LiftMaster, Chamberlain, Genie, or another make, we can help, because a spring job is about understanding your door’s weight and hardware, not selling you a brand.
Signs You Need Garage Door Spring Repair Right Now
- A loud bang from the garage. A spring usually breaks with a sound like a gunshot, and the door stops working right after. If you heard that bang and the door won’t open, don’t try to force it; call us.
- The door feels extremely heavy. If it takes real effort to lift the door by hand, the spring isn’t carrying its share of the weight. That’s a sign of a failed or badly weakened spring, and lifting it can strain your back or the opener.
- The door lifts a few inches and stops. When the opener runs but the door barely moves or reverses immediately, the spring has usually given out. It’s a common sign that the counterbalance system has lost tension.
- A visible gap in the spring coil. Look at the torsion spring above the door; a break shows as a gap or a spring that’s clearly separated. Don’t touch it or try to measure it under tension.
- The door won’t stay up halfway. A balanced door should hold roughly mid-travel. If it slams down or drifts, the spring tension is off or a spring is failing, and it needs adjustment or replacement.
Our Garage Door Spring Repair Process – Step by Step
- 1
We listen and assess. We ask what happened and when, whether there was a bang, and how the door is behaving now. That tells us a lot before we even touch the door.
- 2
We inspect safely under tension. Springs store a lot of energy, so we check the coil, cables, drums, and anchors using proper winding bars and techniques, never by hand. This is the part of the job that has to be done right.
- 3
We balance and measure the door. We measure the door’s weight and test the balance, so the replacement spring is matched to your specific door. A spring that’s the wrong size wears out fast or puts strain on the opener.
- 4
We replace or adjust with the right hardware. New springs go in with matched cables and safety cables where needed, and we reset the drums and tension to spec. Every fastener is checked before the door moves.
- 5
We test and tune. We run the door through a full open and close cycle, set the opener’s force and travel, and confirm the safety reverse works. You get a walk-through of what was done and why.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Spring Repair Cost in Florissant?
Spring repair in Florissant typically runs $180 – $340, and that covers one spring, matched to your door and installed with the right tension and testing. A matched pair is usually replaced together, so a pair costs about twice that range. If a cable also needs attention, cable repair runs $130 – $250. A simple spring adjustment or inspection sits at the lower end of the range, while a full replacement on a two-spring door lands higher. Call (844) 943-4245 for an exact quote; estimates are free.
What affects the price: whether it’s one spring or a pair, the type (torsion vs. extension), whether cables or drums need replacing at the same time, and how accessible the door is. You avoid overpaying by getting a written estimate before any work starts, which is exactly what we do. The written estimate sets the final price, and the price is agreed before we begin, so there are no surprises when the invoice comes.
Typical Estimated Ranges in Florissant
| Service | Estimated Range |
|---|---|
| Spring Repair (one spring) | $180 – $340 |
| Matched Pair (two springs) | About twice the single-spring range |
| Cable Repair | $130 – $250 |
| Opener Repair | $120 – $320 |
| Panel Replacement | $250 – $500 |
| Track Realignment | $120 – $240 |
| Roller Replacement | $110 – $220 |
Garage Door Spring Repair Near Florissant – Our Service Area
We cover spring repair across Florissant and the surrounding communities, including Ferguson, Bridgeton, St. Ann, Bellefontaine Neighbors, Jennings, Spanish Lake, Overland, and Old Jamestown. We also reach Hazelwood, Clayton, and Creve Coeur. For a nearby job like garage door spring repair in Ferguson or a call from garage door spring repair in Bridgeton, we can often get out the same day. Spring work is usually scheduled quickly, and we’ll give you a realistic window when you call.
Serving Florissant, MO – Our Local Coverage Area
We serve Florissant and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Florissant
Garage door spring repair is replacing or adjusting the spring that counterbalances the weight of your door so it opens and closes safely. It covers torsion springs (the twisted coil above the door) and extension springs (the stretched springs along the tracks), plus the cables and safety hardware that keep them contained. It’s not a DIY job, because the springs are under heavy tension and can cause serious injury if handled wrong. We do the job with the right tools and check the door’s balance before we leave.
Most single-spring repairs take about one to two hours, and a matched pair usually runs longer, often two to three hours depending on the door. The work includes the swap, the balance check, and adjusting the opener to match. We’ll give you a realistic time estimate when you call. If you need it back in working order the same visit, we’ll do our best to make that happen.
Typical spring repair in Florissant runs $180 – $340 for one spring, with a matched pair costing about twice that. Cable repair, if needed, adds $130 – $250. The written estimate sets the final price, and we agree on it before any work starts, so you know the number up front. Call (844) 943-4245 for an exact quote; estimates are free.
We work on the brand already in your garage, including Raynor, LiftMaster, Chamberlain, and Genie, along with the other major makes. That brand fluency means we know how your specific counterbalance setup and opener behave once the springs are replaced. You don’t need to guess whether a technician knows your hardware. If you tell us the make when you call, we’ll come prepared.
Yes, we offer emergency garage door service for a broken spring that leaves your door stuck, your car trapped, or your home exposed. A snapped spring is a common emergency call we handle, and we can often get out the same day. Call (844) 943-4245 and tell us what happened. If it’s outside our usual hours, we’ll book you into the earliest available slot, including early mornings or Sundays.
We stand behind our spring work, and we’ll explain the coverage on the parts and labor on the written estimate before we start. If something isn’t right after the job, we want to hear about it. Ask us about warranty specifics when you call so you have the details in writing. That’s part of doing right by you.
Clear the area around the garage door and move anything fragile away from the door and tracks. If you can, have the make and model of your door and opener handy, and note what happened and when. Don’t try to open the door by hand or force the opener, since a failed spring makes the door unpredictable. Leave the rest to us when we arrive.
Schedule Your Garage Door Spring Repair Service in Florissant Today
A broken spring won’t fix itself, and forcing the door only risks more damage. Call (844) 943-4245 to schedule your spring repair in Florissant, with same-day service often available and emergency support for urgent failures. You’ll get a free estimate, and the price is agreed before any work starts. Garage doors are all we do, so let’s get your door back in working order.
Written by the team at Garage Door Repair Florissant.